Chlorine detector is used to detect and warn of dangerous (toxic) concentrations in a timely manner. The E2608-CL2 detectors are designed to detect hazardous chlorine concentrations in swimming pools and spas, wastewarer treatment plants and other confined spaces, where potentially toxic concentration of chlorine can accumulate. The DM design allows the detector to be installed directly into the duct.

Chlorine is heavier than air. Therefore, chlorine detectors should be mounted approximately 15cm above the floor. When used in air ducts it is placed directly at the flow point.

The EVIKON E2608-CL2 detector is equipped with two-stage signaling with outputs to the switching relay. It does not have its own visual and acoustic signaling. The E2608 series detectors are an intelligent solution for modern applications with ModBus RS485 communication and two 4-20mA/0-10V analog outputs.

The detector can be ordered in the following versions:

• wall-mount (in stock)
• duct-mount (on request)
• with cable probe (on request)

Made in robust design with IP65 protection - ABS plastic, resistant to mechanical damage. Rigid, tough, resistant to low and high temperatures, poorly absorbent, harmless to health. The service life of the detector is more than 10 years.

Each detector is factory calibrated to the default values (described in the manual). The law states that recalibration must be performed at least once every 12 months. Calibration may only be performed by a person certified by the manufacturer.

Do not hesitate to contact us for recalibration!

The detector is designed to detect chlorine:
CL2

Features:

• Selective, sensitive and stable detection
• Long-life electrochemical sensor
• Wall, duct mounting, remote probe, IP65 protection
• Two output relays for alarm/ventilation control
• Two analog outputs 4-20mA/0-10V
• Digital communication ModBus RS485

Tip: Get notified by the service about the date of legal calibration www.kalibrovat.cz