The flammable gas detection sensor is used for detecting and providing early warning of dangerous (toxic) concentrations. The DM design allows the sensor to be installed directly into HVAC ductwork. 

Detectors should be mounted at a height above the floor according to the gas being detected. When used in HVAC ductwork, the sensor is placed directly in the airflow.

The EVIKON E2608-LEL detector is equipped with a two-stage alarm with outputs to switching relays. It does not have its own light and sound alarm. The E2608 series detectors are an intelligent solution for modern applications with ModBus RS485 communication and two analogue outputs 4-20mA/0-10V.

The sensor can be ordered in the following versions:

• wall-mounted (in stock)
• for HVAC duct (on request)
• with cable probe (on request)

Manufactured in a robust design with IP65 protection - ABS plastic, resistant to mechanical damage. Rigid, tough, resistant to low and high temperatures, low absorbency, non-toxic. The sensor's lifespan is more than 10 years.

Each sensor is factory-calibrated to default values (described in the manual). The law requires recalibration at least once every 6 months. Calibration can only be performed by a person certified by the manufacturer.

Do not hesitate to contact us for recalibration!

THE DETECTOR IS CALIBRATED FOR HYDROGEN.

The sensor is designed for detecting flammable gases:
Methane (CH₄), Propane (C₃H₈), Butane (C₄H₁₀), Hydrogen (H₂), Acetylene (C₂H₂)

Features:

• Selective, sensitive, and stable detection
• Long sensor lifespan
• Wall mounting, duct mounting, remote probe, IP65 protection
• Two output relays for alarm/control of ventilation
• Two analogue outputs 4-20mA/0-10V
• Digital communication ModBus RS485

Tip: Get automatically notified of the statutory calibration date with the service www.kalibrovat.cz