The flammable gas detection sensor is used for detection and early warning of dangerous (toxic) concentration. The DM version allows the sensor to be installed directly in the ventilation duct.

Detectors should be mounted at a height above the floor according to the detected gas. When used in ventilation ducts, the sensor is then placed directly at the point of flow.

The EVIKON E2608-LEL detector is equipped with two-stage signaling with switching relay outputs. It does not have its own light and sound signaling. E2608 series detectors are an intelligent solution for modern applications with ModBus RS485 communication and two 4-20mA/0-10V analog outputs.

The sensor can be ordered in the following version:

• wall mounted (in stock)
• to the ventilation duct (on request)
• with cable probe (on request)

Made in a robust design with IP65 protection - ABS plastic, resistant to mechanical damage. Rigid, tough, resistant to low and high temperatures, not very absorbent, harmless to health. The service life of the sensor is more than 10 years.

Each sensor is factory-calibrated to default values (described in the manual). The law states that recalibration must be carried out at least once every 6 months. Calibration can only be performed by a person certified by the manufacturer.

Do not hesitate to contact us for recalibration!

THE DETECTOR IS CALIBRATED FOR HYDROGEN.

The sensor is designed to detect flammable gases:
Methane (CH ₄ ), Propane (C ₃ H ₈ ), Butane (C ₄ H ₁₀ ), Hydrogen (H ₂ ), Acetylene (C ₂ H ₂ )

Properties:

• Selective, sensitive and stable detection
• Long sensor life
• Mounting on the wall, in the channel, remote probe, protection IP65
• Two output relays for alarm / ventilation control
• Two analog outputs 4-20mA/0-10V
• ModBus RS485 digital communication

Tip: Let the www.kalibrovat.cz service automatically notify you of the legal calibration date