The Wilo TMR32 / 11 submersible slurry pump with float is an irreplaceable helper for pumping water at home. The pump is ready for fully automated operation. It is light and easy to carry, it is suitable for both fixed and mobile installation . It is possible to use a pressure hose or pipe for water drainage (especially for permanent placement).

The engine is cooled by the surrounding medium , it transfers its residual heat to the surroundings through its casing. In the event of overheating, the pump switches off and restarts after it has cooled down. The hydraulics are separated from the engine by a sealing chamber filled with white oil. There is a shaft sealing ring on the motor side and a mechanical seal on the hydraulic side.

The pump can suck up the medium up to a minimum level height of 2 mm , thanks to a special suction basket.

Using the pump

Pumping clean or slightly contaminated water:

• from tanks, shafts and excavations
• during floods and floods
• from sinks
• during drainage of cellars
• water without faeces and long-fiber components

Features and equipment of the pump

• float switch (factory mounted)
• connecting cable with a length of 4 m incl. "Schuko" plugs
• cooling by bypassing the pump casing
• thermal control of the engine
• IP68
• pumped medium temperature +3 ... + 35 ° C (for a short time up to 3 minutes, the medium can be pumped up to a temperature of 90 ° C)
• max. immersion depth 1 m
• discharge port Rp 1 1/4 (female thread DN32).

Scope of delivery

• pump
• cable with plug
• installed float switch
• threaded connection with check valve
• hose connection
• installation and operating instructions