The refrigerant detection sensor is used for detecting and providing early warning of dangerous (toxic) concentrations of the monitored refrigerant. It is important to detect leaks of previously used chlorofluorocarbons (CFCs) as well as today's hydrofluorocarbons (HFCs). Leaks of these gases have a negative impact on the environment and the formation of the ozone layer. In the event of a leak, refrigerant can accumulate in enclosed spaces to toxic levels. Therefore, it is necessary to ensure early warning of leaks using a detector.

Hydrocarbon refrigerants tend to sink because they are heavier than air. Therefore, refrigerant detectors should be installed near the floor, close to potential leak points. The recommended coverage area for one detector is 80...120m2, which corresponds to a radius of approximately 5...6m.
Refrigerant detectors have a wide range of applications, from kitchens and restaurants to cold storage, warehouses, supermarkets, ice rinks, and food industry factories.

The EVIKON E2608-HFC detector is equipped with a two-stage alarm with switching relay outputs. It does not have its own light and sound alarm. The E2608 series detectors are an intelligent solution for modern applications with ModBus RS485 communication and two analogue outputs 4-20mA/0-10V.

The sensor can be ordered in the following versions:

1. wall-mounted (this one)
2. for HVAC duct
3. with cable probe (on request)

Manufactured in a robust design with IP65 protection - ABS plastic, resistant to mechanical damage. Rigid, tough, resistant to low and high temperatures, low absorbency, non-toxic. The sensor's lifespan is more than 10 years.

Each sensor is factory-calibrated to default values (described in the manual). The law requires recalibration at least once every 12 months. Calibration can only be performed by a person certified by the manufacturer.

Do not hesitate to contact us for recalibration!

The sensor is designed to detect refrigerants:
R-12, R-123, R-125, R-134a, R-143, R-22, R-404a, R-407c, R-410a, etc.

Features:

• Selective, sensitive, and stable detection
• Long lifespan MOSFET sensor
• Wall mounting, duct installation, remote probe, IP65 protection
• Two output relays for alarm/ventilation control
• Two analogue outputs 4-20mA/0-10V
• Digital communication ModBus RS485

Tip: Get automatically notified of the legal calibration date with the service www.kalibrovat.cz