Carbon Monoxide Detector is used to measure the values of detected gas in the air and provide timely warning against dangerous (toxic) concentrations. Solvent fumes can explode at high concentrations. Therefore, it is necessary to ensure timely warning of leakage using a detector.

It does not have its own light and sound signaling. The E2670 series detectors are an intelligent solution for modern applications with ModBus RS485 communication and two analog outputs 4-20mA/0-10V. They are also equipped with two switching relays that activate connected devices after recording two pre-set values.

Manufactured in a robust aluminium design with IP66 protection, resistant to mechanical damage. Rigid, tough, resistant to low and high temperatures, non-toxic. Suitable for use in ATEX zones 2 and 22. More details about ATEX can be found in the declaration of conformity and data sheet.

Each detector is factory-calibrated to default values (described in the manual). According to user needs, the detector can be set to a toxicity range of 0...1000 ppm. The law states that recalibration must be performed at least once every 6 months. Calibration can only be carried out by a person certified by the manufacturer.

The recommended coverage area for one sensor is 80-120 m², 5-6 m radius.

For recalibration, do not hesitate to contact us!

Features:

• Sensitive and stable detection
• Long lifespan of the electrochemical sensor
• Wall mounting, IP66 protection
• ATEX zones 2, 22
• Two analog outputs 4-20mA/0-10V
• Digital communication ModBus RS485
• 2 x switching relays

Tip: Get automatically notified of the legal calibration date with the service www.kalibrovat.cz