SMP28 electric drive with 230 VAC power supply with 2-point control signal in plastic housing. The drive is without a return spring, so it is necessary to connect both a switching phase for controlling the valve and a permanent phase so that the drive (valve) returns to its original position after disconnecting the control signal. If the power supply fails, the rotating part of the actuator (valve) remains in the given position. When the valve is fully open, the auxiliary switch is activated and remains active until the valve is closed.

Use:

• heating systems
• air conditioning systems

Properties:

• power supply 230 VAC
• SPDT control
• drive without return spring
• Installation directly on the valve
• six-wire cable with a length of 80 cm
• torque 18 Nm
• run time 60 s
• manual control and position indication
• LED indication of operation
• built-in auxiliary contact
• without maintenance

Manual control:

By pressing button "A" it is subsequently possible to readjust the drive by turning ring "C" between positions 0...10. The surround can be pulled out for easier access and pushed back again after resetting to a new position.

Operation indication:

The LED light indication indicates the operating status of the drive. In active mode, the LED under the rotating bezel lights up, in idle mode, the LED is off.

For ball valves:

• two-way - I/VBZ
• three-way - TG/VBZ

Connection options:

The drive can be connected directly to the valve without an adapter.